Other

What is the default username and password of Cisco?

What is the default username and password of Cisco?

The default username and password is cisco.

Where is the password on a Cisco router?

Perform these steps in order to recover your password:

1. Either switch off or shut down the router.
2. Remove the compact flash that is on the rear of the router.
3. Switch on the router.
4. Once the router is on Rommon mode, reinsert the compact flash.
5. Type confreg 0x2142 at the rommon 1> prompt in order to boot from Flash.

What is Cisco router login?

Default logins for Cisco 39 % IP Address: 10.0.0.1 Username: admin Password: password. 33 % IP Address: 192.168.1.1 Username: cisco Password: cisco. 17 %

How do I access a Cisco switch?

Access the GUI of the Switch

1. Open up a web browser.
2. Enter 192.168.
3. If you see a login screen, skip to Step 8.
4. A new screen will open and you need to click on Proceed to (IP address used to access the switch) (unsafe).
5. Click Add Exception.
6. Click Confirm Security Exception.
7. You then need to enter a username and password.

What is default administrator password?

Modern-Day Windows Admin Accounts Thus, there’s no Windows default administrator password you can dig up for any modern versions of Windows. While you can enable the built-in Administrator account again, we recommend that you avoid doing so.

How do you reset your Cisco password?

Reset Cisco router to default password. If you decide to revert your Cisco router to it’s factory defaults, you should do the 30-30-30 reset as follows: When your Cisco router is powered on, press and hold the reset button for 30 seconds.

Is there a default admin user password and name?

The default username and password can be obtained from the router manual which comes with the router when you first purchase and install it. Generally, for most of the routers, the default username and password is “admin” and “admin”. However, these credentials may vary depending upon the maker of the router. If you have misplaced the manual, then one can discover the default credentials from the router hardware itself as they will be written on the side of every router.

How to reset Cisco router passwords?

Either switch off or shut down the router.

Remove the compact flash that is on the rear of the router.

Switch on the router.

reinsert the compact flash.

Type confreg 0x2142 at the rommon 1> prompt in order to boot from Flash.

Type reset at the rommon 2> prompt. The…

What is the default login for Cisco switch?

Along with this password, like most Cisco devices, the SG300-28 uses the default username of cisco to login with administrative privileges. To access the Cisco SG300-28 switch, use the default IP address 192.168.1.254.