Popular articles

How hard is Waspaloy?

How hard is Waspaloy?

Machining Waspaloy Waspaloy is difficult to machine, due to its strength, low thermal conductivity, abrasiveness and tendency to work harden. It has a turning machinability rating of 1.0 (bar, forge), 1.1 (cast) and a drilling machinability rating of 14% (bar, forge), 16% (cast).

What is Waspaloy made of?

Waspaloy is a nickel-based superalloy used in very extreme environments. This metal is often used in applications involving very high temperatures, like in gas turbines. Waspaloy is nominally composed of Nickel 58%, chromium 19%, cobalt 13%, molybdenum 4%, titanium 3%, and aluminum 1.4%.

Is waspaloy magnetic?

Waspaloy is a nickel based, austenitic, precipitation hardening alloy. This alloy is non-magnetic, has good oxidation and corrosion resistance up to 1600° F.

What Cmsx 4?

CMSX-4 is an ultra high strength, single crystal alloy development of the Cannon Muskegon Corporation. This second generation rhenium-containing, nickel-base single crystal alloy is capable of higher peak temperature/stress operation of at least 2125°F (1163°C). Large tonnages of CMSX-4 have been produced.

What is waspaloy used for?

Waspaloy is used for gas turbine engine components that require considerable strength and corrosion resistance at high operating temperatures, including compressor and rotor discs, shafts, spacers, seals, rings and casings, and other miscellaneous engine hardware, aircraft assemblies and missile systems [30].

What is the difference between Inconel and Monel?

Have you ever wondered what the difference is between INCONEL® and MONEL®? In the most basic terms INCONEL® is a nickel-chromium alloy whereas MONEL® is a nickel-copper alloy. Both metals are commonly used in applications with extreme heat, high temperature corrosion, and generally severe conditions.

How Stellite coating is applied?

Kennametal Stellite uses various thermal spraying techniques to apply wear-resistant coatings to components, including High Velocity Oxygen Fuel (“HVOF”) spraying, plasma spraying, and flame spraying.

What kind of alloy is Waspaloy round bar?

Waspaloy® round bar – AMS 5708 (Type 2 is capable of AMS 5709) is a nickel-based alloy containing chromium and cobalt typically used in aircraft fasteners where high strength up to 1500° F and oxidation resistance up to 1750° F is required. Waspaloy® round bar is multiple melted, usually with…

Which is the best hardness for Waspaloy bar 5706?

Hardness. Waspaloy® Bar – AMS 5706 exhibits best machinability in this condition. After machining, parts are normally stabilized at 1550ºF (843˚C) for 4 hours, air cooled, followed by precipitation aging at 1400ºF (760˚C) for 16 hours, air cooled. The hardness of this alloy in the fully heat treated condition ranges from 34 to 44 Rockwell C.

Which is the best Waspaloy bar for machining?

Waspaloy® Bar – AMS 5706 exhibits best machinability in this condition. After machining, parts are normally stabilized at 1550ºF (843°C) for 4 hours, air cooled, followed by precipitation aging at 1400ºF (760°C) for 16 hours, air cooled.

Can a Waspaloy alloy be hot or cold?

Waspaloy alloy can be cold- formed in the annealed condition, and may also be hot-formed at temperatures of 1900°F (1040°C) or above. Weldability us somewhat limited by susceptibility to strain age cracking under conditions of heavy restraint. The alloy exhibits good resistance to gas turbine com-