Where is the thermal fuse on a dryer Samsung?
Where is the thermal fuse on a dryer Samsung?
To find and test the thermal fuse on your dryer, it will usually be mounted on the back of the dryer. Carefully unplug the dryer from the wall, slide out the dryer, and remove the back panel (on some dryer models the side panel or top panel will need to be removed: check your dryer owners manual).
Does a Samsung dryer have a thermal fuse?
That’s why every dryer comes with a thermal fuse. Once you do, you can replace the thermal fuse. Order replacement part #DC47-00015A for Samsung dryers and follow these steps to get your appliance back in working order.
Can you replace a dryer thermal fuse?
A thermal fuse is a one-time use component, but luckily, they are inexpensive and easy to replace. Remember, as the thermal fuse is a safety component, do not use the dryer again until you have replaced it.
Why does my Samsung dryer have no power?
When your dryer doesn’t power on, it could be something as simple as a tripped breaker or loose power cord. Always switch off the circuit breaker before interacting with the dryer’s power cord, to avoid electric shock. …
Where is the thermostat on a Samsung dryer?
On most Samsung dryers the Thermistor is attached to the vent or motor area under or behind the drum. The Thermistor is a small plastic part that is about one inch wide. You will see there are 2 wires attached to it.
Where is the heating fuse on a dryer?
Slide the panel off to the side of the dryer. Locate the thermal fuse on the heating element housing on the right side of the dryer. The fuse is an oval-shaped part located near the top of the housing.
Where is the thermal fuse on a Samsung electric dryer?
In most cases, the thermal fuse will be located behind the rear dryer panel or bottom kick panel. Depending on the model, kick panels can be removed by releasing the two metal clips holding it in place or by using a flathead screwdriver to pop the panel off.
When does a dryer fuse blow?
When the critical temperature is reached , the thermal fuse blows . Usually, this is happening at the end, when the dryer goes to the Cool Down cycle. When this occurs, you’ll need to replace the thermal fuse and entire control board, because the relay is stuck.