Popular articles

How is EIGRP for IPv6 configuration done?

How is EIGRP for IPv6 configuration done?

The EIGRP for IPv6 routing process will use the shut down feature. With the EIGRP for IPv6, the router ID is needed on the each router or a routing process will not start. The EIGRP for the IPv6 is configured directly on a router interface.

Is protocol A IPv6?

IS-IS Single-Topology Support for IPv6. Single-topology support for IPv6 allows IS-IS for IPv6 to be configured on interfaces along with other network protocols (for example, IPv4 and Connectionless Network Service [CLNS]). All interfaces must be configured with the identical set of network address families.

Which is better OSPF or EIGRP?

EIGRP vs OSPF: Scalability. The scalability of the OSPF is higher than EIGRP because EIGRP is complicated and vendor-specific and incapable of migrating from one vendor to the other. Conversely, OSPF is an open standard and simple protocol through which the network can be scaled easily.

How do I start EIGRP?

To configure EIGRP in the Cisco IOS, just follow these steps:

  1. Set the bandwidth on your interfaces using the bandwidth command.
  2. Start the EIGRP routing process and specify your AS number.
  3. Once you are through this stage, next step is to instruct the router in order to advertise the networks that are directly linked to it.

How to enable EIGRP for IPv6 on Cisco routers?

1. Global IPv6 Enable on Routers 2. EIGRP for IPv6 Process Creation 3. Router-ID Assign 4. EIGRP Process addition under Interfaces 5. Passive interface configuraiton 6. Verification Let’s see each of this EIGRP for IPv6 configuration example one by one. First of all we enable IPv6 routing on all routers.

What’s the difference between EIGRP version 4 and version 6?

There are few major differences between the version 4 and version 6 are such as: The EIGRP for IPv6 routing process will use the shut down feature With the EIGRP for IPv6, the router ID is needed on the each router or a routing process will not start. The EIGRP for the IPv6 is configured directly on a router interface.

Can a VPN be configured in an EIGRP named configuration?

An EIGRP named configuration does not create an EIGRP routing instance by itself; it is a base configuration that is required to define address-family configurations that are used for routing. In EIGRP named configurations, EIGRP VPNs can be configured in IPv4 and IPv6 named configurations.

How to use Cisco feature navigator for IPv6?

To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required. This section lists ways in which EIGRP for IPv6 differs from EIGRP IPv4 and lists EIGRP for IPv6 restrictions: EIGRP for IPv6 is directly configured on the interfaces over which it runs.