Helpful tips

How do I connect to Buffalo LinkStation?

How do I connect to Buffalo LinkStation?

Knowledge Base

  1. Connect the LinkStation to your network using the supplied Ethernet cable.
  2. Plug in the AC adapter and connect to the LinkStation.
  3. Power on the LinkStation by moving the switch on the rear of the unit to “On”.
  4. Open NAS Navigator.
  5. Right-click on the LinkStation and choose “Settings” from the pop-up menu.

How do I reset TeraStation pro?

To reset the TeraStation to its factory default settings, power on the unit and hold down the reset button for five seconds. In the Web Admin interface, you can initialize almost all settings, including things that are not initialized from the reset button without the data saved in the TeraStation.

How do I configure TeraStation?

Knowledge Base

  1. Setup your Buffalo NAS out of the box.
  2. The first step is to set the administrator password.
  3. Select your time zone.
  4. Configure the proxy server if your TeraStation is located on the network through the proxy server.
  5. Configure the Remote Management Service if you are using this service.
  6. Select the RAID type.

How do I connect Buffalo LinkStation to my computer?

NAS Navigator2 will proceed by setting up Automatic IP….How to: Connect a TeraStation or LinkStation directly to a PC.

1. Connect the Ethernet cable from PC LAN port to the NAS device.
2. For a PC, double-click the icon. For Mac OS, click the icon in the Dock. NAS Navigator2 will start.
3. Click [Refresh].

How do I set my router name and password?

How to Change Your WiFi Name and Password

  1. Open a web browser.
  2. Then type your router’s IP address into the search bar and press the Enter key.
  3. Next, enter your router’s username and password and click Sign In.
  4. Then click Wireless.
  5. Next, change your new WiFi name and/or password.
  6. Finally, click Apply or Save.

How to reset your Buffalo Linkstation Pro Duo device?

The most common caused the data loss from NAS storage includes: To reset the Buffalo Linkstation Pro Duo device, one may follow the step by step guidance mentioned in the manual. Resetting the device will restore all your factory settings back as it is. In simple terms it will revert it to the default settings.

How to restore the LinkStation to its factory settings?

1. Turn off the LinkStation. 2. Turn the LinkStation on with holding down the function button. The function LED will flash white. 3. Press the function button again while the LED is flashing. The LinkStation will reboot automatically. When the LED changes to a steady white, the initialization has been done.

Is there a way to reset the password for the LinkStation?

To reset the password for the LinkStation, initialize the LinkStation to its factory default with the function button. For LS-XL, initialize the LinkStation from Settings. 1. Turn off the LinkStation.

How to recover lost information from LinkStation duo?

The chances for recovery depend on the original NAS configuration: If the previous configuration was set as “maximum speed and capacity” and the drives weren’t swapped before resetting, the file system of NAS was formatted. To recover the lost information run ‘Data Recovery’ scan enabling the ‘File system reconstruction’ option.